The modem dials and appears to complete the connection, but the communications software does not enter the correct mode. (The screen remains blank)

* There may be an I/O conflict (see the solution for the previous problem).
* The Result Codes may have been disabled by the software configuration set up. Check if Q1 is in the configuration or initialization string. If so, change it to Q0.
* Your software may require numeric result codes rather than verbal result codes. Use either V0 for numeric result codes or V1 for verbal result codes in your initiazation or configuration string.
* Some software require full extended result codes (i.e., CONNECT 33600 instead of CONNECT). This can be controlled by the Xn command. X0 sends a summarized code (CONNECT) and X4 sends a full extended code (CONNECT 33600)

__________________
Shaalini.S
Be the Best of Whatever you are...